 |
|
Your Total Business Solution!
DSL, Dial-Up & Satellite!
|
44 N. 4th St.
Zanesville, OH. 43701
(740)-453-5953
(fax) (740)-453-5954
1-800-281-4624
info@icsisp.com |
|
|
|
DSL Modem Setup:
1. Installing Phone Filters:
You must install the included Phone Line Filters on every device (phones, fax
machine, satellite receivers etc.) that is connected to the same line as your
new DSL.
2. Install DSL Modem
1. Plug the included Phone Line Splitter into your Wall Jack. If you are going
to be using another device (phone, fax machine, satellite receiver etc.)
plug-in one of your Phone Line filters into the Splitter and then plug your
phone into the filter. On the other side of the splitter hookup your DSL modem
directly with the supplied phone cable. Be sure to plug it into the LINE or DSL
port on the back of your modem.
2. Make sure your computer is turned off.
3. Take the supplied Ethernet cable and plug it into the LAN or ETHERNET port
on the back of the modem. Plug the other end of the cable into the Ethernet
port on the computer.
4. Plug the supplied power cord into the modem and then into an available plug
nearby. Once you plug-in the power supply, the modem will turn on automatically.
If there is a switch on the back of the modem make sure to flip it to the ON
position.
5. Once the READY, SYNC/PPPoE or LINE light on the front of the modem stops
blinking, turn your computer on and you will be ready to surf the internet!
6. If the READY, SYNC/PPPoE or LINE light continues to blink for longer than a few
minutes and it is PAST your scheduled due date for
DSL, please call our Technical Support.
If you have further questions or problems please call:
740-453-5953 – John Share (Technician/Consultant)
Or go to the address:
Image Computer Solutions
44 North 4th Street
Zanesville, OH 43701
If you are online and have questions please go to our website:
http://www.icsisp.com
|
|
|
|
|
|
|